Your Personal 2 Minute Quiz

Take our two minute questionnaire to Discover your perfect style and get your reno underway with Beaumont’s What’s My Style! It’s jam packed with inspired designs, style advice and knockout products to help you renovate and style like a star.


Our Style Guru Naomi Findlay

She is Australia’s rapid renovation expert and recognised internationally for beautiful, healthy and wealthy designs. In fact there’s nothing Naomi loves more than helping people maximize the sale value of their property. Naomi is the wiz behind the What’s My Style 2 Minute Quiz.


Our Team of Stylists

Say hello to our star studded line-up of Australia’s most popular stylists and renovators! You’ve seen their amazing work on smash TV shows like The Block, Renovation Rumble and The Living Room. They’re here to help you achieve a rock star reno!


Welcome back


Marking of these tiles is typically surface dirt which can be removed by washing but where the surface is highly porous, staining materials can penetrate and may not be removable. The same applies to stone tiles, and the porous rock types are much more likely to suffer permanent marking and discolouration. Cement based grouts are likewise not necessarily affected by the water, but can also suffer staining that cannot be removed.

'Moisture unstable tiles' - tiles that warp or change dimension - can create problems when flooded because any expansion or warping (usually from the top down) can crack the grout and damage the adhesive bed. Where there is evidence of tile movement or warping it is almost inevitable that the tiles will need to be replaced.

Tile cleaning processes need to be thorough but sympathetic to the types of tiles being cleaned, and the use of mineral acids needs to be very carefully examined, particularly with regards to damaging grouts.

Where the tiles cannot be cleaned or have suffered physical damage there is no choice but to replace them.


Each tile installation will have to be assessed separately, and particular attention should be paid to tiles layed over surfaces damaged by water (plasterboard and timber), but also where there is public risk (such as external and internal facades or fascias) or large and heavy format tiles that have been bonded on vertical surfaces. Where water comes out from under tiles when walked on, it is a good bet that the adhesive system has been damaged and will need to be replaced. Below grade tiled areas are much more likely to require replacement because of longer inundation, but also due to longer ongoing dampness.

How do I treat damp masonry surfaces and cement screeds?

Treat with a moisture barrier system such as a water based epoxy to suppress rising damp and also to some extent obnoxious odours. This can allow earlier rectification and reinstatement of the tiled areas, but at the same time it needs to be recognised that these wet substrates are going to be subject to movements till the dampness dissipates. Sand-cement screed beds can be treated in the same way, but tend to be contaminated sufficiently that they would be better replaced.

Do I need to remove existing adhesive bed, or concrete block?

Yes, this is very important and concrete or block work must be mechanically prepared which will also remove contaminants from the immediate concrete surface. Render may be able to be prepared in the same way, but it is more likely to suffer mechanical damage and require removal and replacement.

Should I tile over timber floors?

We do not recommend taking short-cuts such as severe sanding back of timber floors for direct installation or re-sheeting and tiling.

Can I prepare for any future flooding?

Where there is risk of further flooding, the use of adhesives suitable for full immersion such as those used in swimming pools may make a tiled installation on masonry surfaces more resistant to damage, though only correct detailing and avoidance of adhesive voids will reduce problems with debris trapped in the bed.

Beaumont Tiles can offer a range of ABA and Ardex products to remedy your situation and can offer advice and expertise in store and VIA the ABA Technical Services free call number. ABA Technical Services can be contacted on 1800 300 863.

You can download this information as a PDF, including the ABA Internal Product Selector here